Product Description
Easy Brick Cleaner is a unique formulation that cleans and restores all types of block or brick surfaces. It can be used on any color brick but is especially effective on red or dark colored brick. For Exterior Use Only.
TYPICAL USES: For industrial, commercial and residential use on brick walls, sidewalks, driveways, buildings, shopping centers and streets.
PRODUCT ADVANTAGES: Fast and Easy to Apply * Will Not Harm Mortar * Removes Stubborn Stains * Easy Clean Up
COLOR: Orange-Yellow
PHYSICAL CONSTANTS:
* Boiling Point: 212F
* Specific Gravity: 8.7 WT. +/- .04
* Solubility in Water: Excellent
* Evaporation Rate: Same as Water
* pH: 1.2
* % Volatile by VOL: N/A
* Vapor Pressure: N/A
* Vapor density: N/A
APPLICATION:
Method: Brush, Roll, or Spray
Theoretical Coverage: 200-250 square feet per gallon
Application Instructions:
ALWAYS TEST ON SURFACES PRIOR TO APPLICATION!
Limitations: Apply in good weather when air and surface temperature are above 45 F. and surface temperature is at least 5 F. above the Dew Point. For optimum application properties, materials should be between 70-90 F. prior to application. Maintain unused material in closed containers in protected storage at 40-90 F out of direct sunlight. This product is considered Corrosive.
SURFACE PREPARATION: Always test before application
1. Water all surrounding grass and shrubs well before starting application of Easy Brick Cleaner. Clean all oil and grease off surface using EnviroClean Degreaser. Rinse well. While still damp, apply Easy Brick Cleaner with a plastic garden pump sprayer.
2. Allow 3-5 minutes for Easy Brick Cleaner to deep clean the pores of the surface depending on the extent of the soiling and the durability of the surface (This is why Testing is important)
3. Agitate surface using a stiff nylon brush, broom or rotating concrete scrubber and a 3000 psi pressure washer.
4. Power wash away all dirt and remaining Easy Brick Cleaner and rinse well.
5. Repeat on any stubborn stains scrubbing with a stiff nylon bristle brush. Pressure wash with minimum 3000 psi. Manufacturer recommends OSHA Compliance chemical gloves, eye protection and rubber boots. Rinse everything with plenty of water. Rinse equipment immediately after use.
6. Apply Trojan Masonry Sealer to seal surface and to keep future stains from penetrating.
7. Clean-up: Clean all equipment with EnviroClean Degreaser and water to neutralize
Safety: Safe storage, handling and use dictate that adequate health and safety precautions be observed with this product. User is specifically directed to consult the current Material safety Data Sheet for this product as well as precautions contained on product labeling. This product is considered Corrosive.
SHIPPING & STORAGE:
Container Type: 1 Gallon * 5 Gallon Pail * 55 Gallon Drum
Shipping Weight: 9.4 lbs. * 46 lbs. * 496 lbs.
Average Shelf Life: 12 months minimum from date of manufacture when maintained in protected storage. Storage at 40-90 degrees Fahrenheit
|
