Product Description
Nu Look Concrete Cleaner is an environmentally safe fluid cleaner that removes oil, grease, dirt, tire marks, and stains from concrete, masonry, brick, paver stones and tile. Ideal for restoring the "New Look" finish to industrial, commercial and residential cement surfaces as it creates a whitening effect on the surface.
Note: Nu Look should NOT be used on dark grey, red brick or any colored surface as it might lighten the color. For Exterior Use only.
TYPICAL USES: Sidewalks * Driveways * Pool Decks * Garage Floors * Balconies * Warehouse Floors * Commercial Buildings * Factory Concrete Floors * Streets
PRODUCT ADVANTAGES: An effective stain remover, that is non-flammable, biodegradable, non toxic, non-carcinogenic and water soluble. It will not harm treated cement surfaces, plants or animals.
COLOR: Light Yellow
PHYSICAL CONSTANTS:
* Vapor Pressure: (mm Hg) Greater
* Solubility in Water: Completely
* Boiling Point: 100C/212F Using test tube method
* Freezing Point: 32F (Liquid only)
* Specific Gravity: (H20 1) 1.0 - 1.2 AT 24 C.
* Evaporation Rate: Water = Less than 1 - water
* pH: 1.0
* Weight: 10.00+/- .02
* % Solids: 2%=/- .02
* Viscosity: More than water
APPLICATION:
Method: Brush, Roll, or Spray
Theoretical Coverage: 300 square feet per gallon
Application Instructions:
Limitations: Apply in good weather when air and surface temperature are above 45 F. and surface temperature is at least 5 F. above the Dew Point. For optimum application properties, materials should be between 70-90 F. prior to application. Maintain unused material in closed containers in protected storage at 40-90 F out of direct sunlight . This product will whiten concrete. If this is NOT desired, use either Rust & Stain Remover or Easy Brick Cleaner. This product is considered Corrosive.
SURFACE PREPARATION:
1. Water all surrounding grass and shrubs well before starting application of NuLook Concrete Cleaner. Clean all oil and grease off surface using EnviroClean Degreaser. Apply NuLook Concrete Cleaner with a plastic garden pump sprayer.
2. Allow 3-5 minutes for NuLook Concrete Cleaner to deep clean the pores of the concrete depending on the extent of the soiling and the durability of the surface (This is why Testing is important)
3. Agitate concrete surface using a stiff nylon brush, broom or rotating concrete scrubber and a 3000 psi pressure washer.
4. Power wash away all dirt and remaining NuLook and rinse well. If rust stains are present, apply Rust Stain Remover according to the instructions. Pressure wash off and re-apply NuLook Concrete Cleaner to achieve the whitening.
5. Scrub any stains with a stiff nylon bristle brush. Pressure wash with minimum 3000 psi We recommend OSHA Compliance chemical gloves, eye protection and rubber boots.
6. Rinse everything with plenty of water. Rinse equipment immediately after use.
7. Apply Trojan Masonry Sealer to seal surface and to keep future stains from penetrating.
8. Clean-up: Clean all equipment with EnviroClean Degreaser and water
Safety: Safe storage, handling and use dictate that adequate health and safety precautions be observed with this product. User is specifically directed to consult the current Material safety Data Sheet for this product as well as precautions contained on product labeling. This product is considereCorrosive.
SHIPPING & STORAGE:
Container Type: 1 Gallon * 5 Gallon Pail * 55 Gallon Drum
Shipping Weight: 9.4 lbs. * 46 lbs. * 496 lbs.
Average Shelf Life: 12 months minimum from date of manufacture when maintained in protected storage. Storage at 40-90 degrees Fahrenheit
|
